Meyertech ZoneVu 328 Series Guía de usuario descargar pdf (Pagina 10)

MPOWER CCTV SYSTEM CONFIGURATION SOFTWARE ISSUE 05

MPOWER

Configuration

The Configuration menu is used to access the menus for the specific products – Site Controller, Receiver, Matrix,

Keyboard, Dialup, Peripherals, Cameras or Domes.

On selecting the type of product to be configured a dialog box will be displayed requesting the address information of

the required unit.

Depending on the product being selected some or all of the

selections are enabled.

E.g. To communicate with a ZVR-530 that has an address of 12

and is located at site 3. The Unit Address should be set to 12. The

Site Number should be set to 3. The Monitor number can be set to

the monitor output of a matrix that you wish to view the camera

picture on.

Mpower will automatically switch the camera to that monitor if the

system is active.

The directory path shown is the current root for stored data. This

can be changed as described in a previous section (Setup->Data

Location).

Site Controller

The Site Controller menu is used to access the menus for the ZSC-1000plus, ZSC-1000, ZSC-500, ZSC-250, and

ZSC-250-IP products.

Connection Table

Direct Local Site Remote Site

ZSC-1000plus Yes (PC2 Port) Yes Yes

ZSC-1000 Yes (PC2 Port) Yes Yes

ZSC-500 Yes (PC2 Port) Yes Yes

ZSC-250 Yes (any PC Port) No No

ZSC-250-IP Yes (PC/IP Port) No No

Receiver

The Receiver menu is used to access the menus for the ZVR-510, ZVR-130 and ZVR-530 products.

Connection Table

Direct Local Site Remote Site

ZVR-510 Not yet available

ZVR-130 Yes (*) Yes Yes

ZVR-530 Yes (*) Yes Yes

* an external RS232 to RS422/485 converter required

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 25 26

Sin comentarios

Meyertech ZoneVu 328 Series Guía de usuario Pagina 10